Sanwa Gemini X Spezifikationen PDF herunterladen (Seite 40)

Page 40

When the Binding procedure is successful, the Bind LED will stay solid blue and the Power Indicator Light will ash slowly

when both the transmitter and receiver are turned ON. If the Bind LED on the receiver is ashing rapidly, the transmitter and

receiver are not paired. In this case, turn both the transmitter and receiver OFF, then repeat the Binding procedure.

5) After verifying that the Binding process is complete (solid blue Bind LED on the receiver) and the servos operating normally,

press either the Right MENU key or the Left MENU key to return to the BIND menu.

4) Press the +/INC key a second time.

PUSH DEC will ash. Press the DEC/-

key once. BIND will be displayed in the

Programming Window, the LCD and the

Power Indicator Light will ash, then the

Bind LED on the receiver will turn solid

indicating the Binding process is complete.



SETUP MEnU

The Trim Switch Assign function allows you to assign several different operations to the TRM switch. This

allows you to easily control during use a specic Auxiliary function that you've assigned to the TRM switch.

For example, you could assign the Step Auxiliary function to the TRM switch and control your glow-powered

model's needle valve or your boat's adjustable trim step. In addition, you can change the Step Resolution of

the TRM switch to change how far the servo travels with each press of the TRM switch.

TRM - TRiM SwiTcH aSSign

You can assign and control ONE of the following Auxiliary functions with the TRM switch:

  

D/R

TH_HI

TH_BR

3C_HI

3C_LO

3_SUB

P_AUX

S_AUX

teering Dual rate

throttle high ePa

throttle braKe ePa

auxiliary channel 3 high ePa

auxiliary channel 3 low ePa

auxiliary channel 3 Sub-trim*

Point auxiliary Program

SteP auxiliary Program

controlS Steering Dual rate

controlS throttle high SiDe enD Point aDjuStment

controlS throttle braKe SiDe enD Point aDjuStment

controlS auxiliary channel 3 high SiDe enD Point aDjuStment

controlS auxiliary channel 3 low SiDe enD Point aDjuStment

controlS auxiliary channel 3 Sub-trim

controlS ProgrammeD Point auxiliary Servo movement

control ProgrammeD SteP auxiliary Servo movement

*This Sub-Trim function is only effective when Auxiliary Channel 3 is used as a mixer. In the default conguration,

any servo plugged into Auxiliary Channel 3 will move TO and FROM the HIGH and LOW positions only. It is not

a proportional channel that features a center position. However, when being used as a mixer, for example, when

controlling front and rear steering, Auxiliary Channel 3 will react as a proportional channel, just like the Steering

and Throttle channels. In this case this Sub-Trim function will work as intended, allowing you to adjust the Auxiliary

Channel 3 servo center trim independently.



1) Press the Right or Left MENU key to highlight the EXP menu. TRM will be displayed in the

Programming Window.

Press the TRM switch up to increase a function value and press the TRM switch down to decrease a function value.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Sanwa Gemini X Spezifikationen Seite 40

Kommentare zu diesen Handbüchern