Sanwa M11x Spezifikationen PDF herunterladen (Seite 56)

Page 56

fail safe

[

FAIL SAFE

]

BATTERY VOLTAGE FAIL SAFE SETTING

Clearing Fail Safe Settings

1) Press the ENTER key to move the cursor next to the channel you

would like to clear the Fail Safe setting from.

2) To reset the predetermined position to 0%, press the INC/+ and

DEC/- keys at the same time.

When TH :FS Percentage is set, [B-FAIL SAFE] menu activates. The Battery Fail Safe menu allows you to set a custom voltage that

the Fail Safe function will Activate at. This useful if you're using servos with a higher than normal current draw that might run out of

power before the receiver does.

The receiver will operate down to 2.5 volts, however, the minimum operating voltage of most servos is higher than that.

B-F/S Setting

1) Press the Function key to move cursor to

[B-FAIL SAFE]

in the

Programming Window. The cursor will default to B-F/S.

2) Press the INC/+ or DEC/- keys to set the desired value.

RX-V Setting

1) Press the ENTER key to move cursor to

RX-V, then p

ress the INC/+

or DEC/- keys to adjust the desired receiver voltage value.

RX-V setting range is 3.5V to 5.0V. The default setting is 3.8V.

3) To change the Fail Safe setting to either HOLD or FREE, press the

INC/+ or DEC/- keys to set the desired value.

INH

ACT

RX-V setting.

4) Repeat the previous procedures to clear the Fail Safe settings for the desired remaining channels.

- Battery Fail Safe is not Active.

- Battery Fail Safe is Active. Fail Safe will Activate when the receiver battery reaches the custom value in the

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 66 67

Keine Kommentare

Sanwa M11x Spezifikationen Seite 56